Garage Door Opener Troubleshooting
Warning: Undertaking repairs to appliances can be hazardous. Use the proper tools and safety equipment noted in the guide and follows all instructions. Do not proceed until you are confident that you understand all of the steps and are capable of completing the repair. A qualified technician should only perform some repairs Call C and M garage Doors. 702-655-3667
Garage Door Opener: Needs preventive maintenance
To keep your garage door opener working efficiently and reliably, maintain it periodically. Maintenance can help you catch developing problems, before they affect the opener’s operation. When you inspect the garage door opener, check whether the door opens and closes smoothly. Tighten brackets and fasteners. Test the safety sensors, check the travel limits, and force limits. Unplug the motor unit and test whether you can open the door with the emergency pull.
These repairs may help solve your Garage Door Opener problem:
Ø Do garage door opener preventive maintenance
To keep the garage door operating smoothly, periodically check the garage door opener for proper alignment and settings, following instructions in the owner’s manual. Inspect hardware and lubricate moving components. Check the safety sensor for proper operation.
- Adjust and align the garage door opener
When the garage door opener does not work, operate properly, check the alignment of the motor unit and/or the rail and realign if necessary. If necessary, adjust the settings for travel limits and force limits, following the instructions in the owner’s manual. Make sure that the photoelectric eyes of the safety sensor are aligned.
- Replace garage door opener brackets
Brackets fasten the garage door opener to the garage door. The brackets can wear out, break or be damaged. Physically inspect the brackets and other door hardware to see whether the components need to be replaced.
Garage Door Opener: Making noise
If the garage door rattles or rumbles as it opens and closes, tighten any loose hardware and replace any broken hardware, which could allow excessive vibration. Check the alignment of the trolley on the garage door opener or the brackets; if you correct the alignment, tighten the hardware.
- Replace the garage door opener gear and sprocket assembly
As the drive shaft and sprocket rotate, they drive the trolley that lifts and lowers the garage door. The plastic gear on the drive shaft is designed to fail if the garage door gets stuck in the travel tracks, protecting the expensive drive motor from damage. If the gear is worn or damaged, the door will not move properly. Replace the gear shaft and sprocket assembly if it has damaged or worn out.
- Replace the garage door opener drive and worm gears
The worm gear attaches to the motor shaft and rotates the drive gear to spin the sprocket, which drives the chain to move the door. Made of plastic, the worm and drive gears strip out to protect the motor from damage if the door suddenly hits an object in its travel path. Replace the drive and worm gears if they are worn or stripped.
- Replace the garage door opener belt
The motor pulley drives the belt to move the trolley along the rail to lift and lower the garage door. If the belt frays or breaks, replace it.
- Replace the garage door opener chain and cable assembly
The sprocket on the motor unit drives the chain and cable assembly. The cable is attached to the trolley that lifts and lowers the garage door. If the chain or the cable is damaged, replace it.
- Replace garage door opener brackets
Brackets fasten the garage door opener to the garage door. The brackets can wear out, break or be damaged. Physically inspect the brackets and other door hardware to see whether the components need to be replaced.
- Replace the garage door opener cable pulley
The cable pulley at the front of the rail of the garage door opener must rotate freely for the door to open and close smoothly. If the cable pulley is worn, bent, or damaged, replace it.
- Do garage door opener preventive maintenance
To keep the garage door operating smoothly, periodically check the garage door opener for proper alignment and settings, following instructions in the owner’s manual. Inspect hardware and lubricate moving components. Check the safety sensor for proper operation.
- Adjust and align the garage door opener
